Hi,

I am getting error at the end of my simulation. I think if i rise the time step there is no problem for me because at the end the values that are going to calculate are not  important for me. So i have increased the time  step it worked out fine.

Thank you veery much fot responding.

Hello,

I am  modeling Automotive power train system in modelica (i.e. on SimulationX environment). I am using 3.1 version. When i am simulating my model, after 135 seconds i got following error;

Error: The solver sould not reach the required accuracy. change the minimal calculation stepsize (dt Min) ot the tolerances.

Convergence test not failed, but error test failed. Changes of states are too big.

Could you please any one suggest me to eliminate this error.

thankyou in advance,