- Index
- » Programming
- » Modelica Language
- » fault mode control
Page Start Prev 1 Next End
fault mode control
fault mode control
Jan-29-16 09:16:28
Can you advise some articles on using fault control in Modelica models ?
For example stop simulation on overheat, electric overvoltage, overload
or (more complex) tracking current parameters in bounds of used model applicability
(for example check signal bounds in case of using low-signal models)
Edited by: dponyatov - Jan-29-16 09:16:38
Page Start Prev 1 Next End
- Index
- » Programming
- » Modelica Language
- » fault mode control
There are 0 guests and 0 other users also viewing this topic