It worked! Thank you very much!

It is located in Buildings.HeatTransfer.Windows.BaseClasses.GasConvection

Hello,

i hope im in the right section here.

The Problem i have with OpenModelica is, that if i put 90 deg as a parameter unit for til in the Class "GasConvection", it will convert it in radiant like shown below.

til (displayUnit = "deg") = 1.5708

When i open the Class "GasConvection" again, it shows 90.0002 and will not accept it, since only 0, 90 and 180 degrees are implemented.

What can i do to make OpenModelica accept 90 degree?

Regards,
Andre