Thank you very much, it works!

Hello ,

I'm a begginer in om edit and I'm curently using OpenHydraulics Librairy.

When I try to simulate my model there is this error :
[1] 10:04:33 Traduction Avertissement
[OpenHydraulics.Interfaces.PartialFluidComponent: 5:3-6:93]: No corresponding 'inner' declaration found for component .OpenHydraulics.Fluids.BaseClasses.PartialFluid accu_6C0.oil declared as 'outer '.
  The existing 'inner' components are:
    There are no 'inner' components defined in the model in any of the parent scopes of 'outer' component's scope: OpenHydraulics.Components.Volumes.Accumulator$accu_6C0.
  Check if you have not misspelled the 'outer' component name.
  Please declare an 'inner' component with the same name in the top scope.
  Continuing flattening by only considering the 'outer' component declaration.

[2] 10:04:33 Traduction Erreur
[OpenHydraulics.Fluids.BaseClasses.PartialFluid: 2:1-64:17]: Illegal to instantiate partial class PartialFluid.

[3] 10:04:33 Traduction Erreur
Error occurred while flattening model Mise_en_charge



I don't put every parameter but i understand the librairy ParatialFluid isn't configured even if idon't use it.

I put my model on the attachments in case of there is others questions.

Thank you for your help
Load-control.mo