Hi.

I am trying to build a model of a hot water system in OMEdit but I cant seem to make the connectors to give the models both the flow and the temperature (or enthalpy) of the component it is connected too.

I want the out port of one component that i connect with the in port of another component to automatically have the same (opposite) flow and the same temperature but I cant seem to get the stream connectors to do the job.

Could anyone make an example where there are 2 sources of water that goes into a component that mixes the flows and then outputs a single flow (with the combined temperature and flow from the sources) that goes into a sink that gets the temperature of the output from the mixer. The pressure is irrelevant in the models I am trying to create.

Im using the latest nightly build on windows if that matters in any way.