Hi Friends,
  I've downloaded the vehicle interfaces library available. Now the problem is, it may  not loading properly (at least examples).
  I tried two examples - Conventional Automatic Vehicle, and the model icons were not loading properly, but I think simulation went good. I've attached the image.


And then I tried Rear wheel Drive automatic vehicle. In this example, unfortunately, I could neither see the icons nor could run example properly. I've attached the image, and also, these are the errors I got.

1] 17:51:23 Symbolic Error
Too many equations, over-determined system. The model has 2001 equation(s) and 1990 variable(s).

[2] 17:51:23 Translation Error
Internal error pre-optimization module clockPartitioning failed.

[3] 17:51:23 Symbolic Error
[VehicleInterfaces.Mechanics: 183:7-183:21]: Found equation without time-dependent variables: driverEnvironment.brakePosition.flange_a.f = 0.0



How do I debug it? How do I check if model is properly loading?

Please let me know what  I can do to resolve issue. Thank you very much.