- Index
- » Usage and Applications
- » OpenModelica Usage and Applications
- » v sin package giving odd output
Page Start Prev 1 Next End
v sin package giving odd output
v sin package giving odd output
Nov-16-13 19:47:41
i am new to modlica. i was implementing a simple RC low pass filter. i selected the v sin package as my input source. initially i tested the circuit at small frequency that is 10,50 Hz.. it was fine but i noticed a small thing. even though i had given the amplitude as 10V it was 9.something , not exactly 10. then i increased the frequency to 500 Hz . the input got distorted. it was like saw tooth voltage increasing slowly but the y-scale was in nanos. i can't proceed any further without getting the correct input. kindly help
Thank you
Re: v sin package giving odd output
Nov-16-13 19:58:21
Have you tried increasing the number of output points? The default is 500 points, and the plot utility doesn't know it is a sine wave so it may not look right even though it is.
- sjoelund.se
-
-
- 1700 Posts
Page Start Prev 1 Next End
- Index
- » Usage and Applications
- » OpenModelica Usage and Applications
- » v sin package giving odd output
There are 0 guests and 0 other users also viewing this topic
